Tri wick holder for a 110mm jar
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.16 – €1.42 net (excluding VAT)
For file: candle wick holder_PLA_1h25m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.29 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 1.25 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I am the original creator of the first file for a 100mm jar. Was asked if it could be edited to fit a 110mm jar.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 23
- Makes
- 0
- Views
- 68
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The ring is designed to fit over the top of a 110mm glass candle jar, as requested by a member of this website, and provides 3 locations to place and secure wicks located on a set radius from the center and an additional center location in the event a single wick candle was being made.
The holes for the wicks are slightly oversized to allow slightly frayed and unraveled wick ends to pass through and each hole has built in wick retention via tapered channels off-shooting from the holes.