Pressure roller from paint roller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Convert your existing paint roller to a two handed pressure roller.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 39
- Wydruki
- 2
- Wyświetlenia
- 518
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use this model to convert your existing paint roller to a two handed pressure roller.
The model is parametric and I attached the Fusion360 file, so if your pressure roller's shaft has different dimensions, you can customize the model before printing.
Printing:
No supports needed, but you have to rotate the cylinder to standing position before printing. I printed both parts from PLA with 0.3mm layer height, 4 perimeters and 25% infill and it is very sturdy. After printing you may need to go through the holes with a drill bit to make them roll nicely.
Assembly:
My paint roller has a 6mm shaft so I could easily cut an M6 thread to the end of it and use a nyloc nut to prevent the parts from moving sideways. I added 3 M6 washers between the parts and under the nut.