Pressure roller from paint roller
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Convert your existing paint roller to a two handed pressure roller.
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 39
- Makes
- 2
- Views
- 518
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Use this model to convert your existing paint roller to a two handed pressure roller.
The model is parametric and I attached the Fusion360 file, so if your pressure roller's shaft has different dimensions, you can customize the model before printing.
Printing:
No supports needed, but you have to rotate the cylinder to standing position before printing. I printed both parts from PLA with 0.3mm layer height, 4 perimeters and 25% infill and it is very sturdy. After printing you may need to go through the holes with a drill bit to make them roll nicely.
Assembly:
My paint roller has a 6mm shaft so I could easily cut an M6 thread to the end of it and use a nyloc nut to prevent the parts from moving sideways. I added 3 M6 washers between the parts and under the nut.