1 / 2
Gaggiuino pogo pin connector holder — zdjęcie 1
1 / 2

Gaggiuino pogo pin connector holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Quick and easy connector for display/stlink etc.

Ocena
0 / 5
Polubienia
4
Pobrania
17
Wydruki
0
Wyświetlenia
397
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This design makes use of the connector's edge to latch onto either the lower or upper part of the ventilation hole. Then the printed part will lock the connector in place. You are able to keep the wires completely inside the machine and the connector is easily removable.

 

Materials

Connector: https://www.aliexpress.com/item/4001283688823.html
Get the ones with the 90 degree pins/solder connections. The straight ones are nearly impossible to solder cables on because they are very small (ask me how I know).

Uses two heat inserts (M3, 5mm OD) and M3 4mm bolts (slightly longer will do as well). Print with ABS/PETG or similar.

Instructions

You have to cut away material from the longer sides of the pogo pin connector until it fits through the vent. Try not to remove material from the ends since they are needed to latch onto the frame.

The small tabs on the printed part are meant to press against one of the connector's end and push it outwards.

Tagi