1 / 2
Gaggiuino pogo pin connector holder — image 1
1 / 2

Gaggiuino pogo pin connector holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Quick and easy connector for display/stlink etc.

Rating
0 / 5
Likes
4
Downloads
17
Makes
0
Views
389
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

This design makes use of the connector's edge to latch onto either the lower or upper part of the ventilation hole. Then the printed part will lock the connector in place. You are able to keep the wires completely inside the machine and the connector is easily removable.

 

Materials

Connector: https://www.aliexpress.com/item/4001283688823.html
Get the ones with the 90 degree pins/solder connections. The straight ones are nearly impossible to solder cables on because they are very small (ask me how I know).

Uses two heat inserts (M3, 5mm OD) and M3 4mm bolts (slightly longer will do as well). Print with ABS/PETG or similar.

Instructions

You have to cut away material from the longer sides of the pogo pin connector until it fits through the vent. Try not to remove material from the ends since they are needed to latch onto the frame.

The small tabs on the printed part are meant to press against one of the connector's end and push it outwards.

Tags