1 / 6
Milwaukee M12 battery 12V/24V power supply
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple 12V/24V power supply using M12 battery's
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 236
- Wydruki
- 1
- Wyświetlenia
- 2164
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 4)Remiksy (0)Kolekcje (44)Powiązane
I'm working with 12V and 24V vehicles where I have to test single components. because I have a 12V Milwaukee M12 battery powered drill. I designed this handy power supply.
Both parts can be printed without supports.
Additional hardware:
- 3x M4x16 hex bolt
- 6x M4 hex nut
- 3x M4 ring
- 7x dual male spade connector (example)
Build instructions:
- print out the 2 parts
- fold open one side of the 7 dual spade connectors
- cut of one side of 3 connectors
- drill out the small hole on the flattened spade of the other 3 connectors to 4mm
- place 3 M4 nuts in the 3 hex holes on the bottom of the top part
- place the 4 drilled out connectors true the slots and with the hole over the nuts
- put in the 3 M4 bolts. tighten them and make sure the hex head is in de correct orientation
- flip the part over and put on the 3 cut down connectors, 3 M4 rings and 3 M4 nuts
- when tightening the nuts make sure the bold head doesn't rotate
- put on the bottom plate (use glue in necessary)
Put in 1 or 2 battery's and your good to go