1 / 6
Milwaukee M12 battery 12V/24V power supply — image 1
1 / 6

Milwaukee M12 battery 12V/24V power supply

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple 12V/24V power supply using M12 battery's

Rating
5 / 5
Likes
29
Downloads
236
Makes
1
Views
2,164
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

I'm working with 12V and 24V vehicles where I have to test single components. because I have a 12V Milwaukee M12 battery powered drill. I designed this handy power supply.

Both parts can be printed without supports.

Additional hardware:

  • 3x M4x16 hex bolt
  • 6x M4 hex nut
  • 3x M4 ring
  • 7x dual male spade connector (example)

Build instructions:

  • print out the 2 parts
  • fold open one side of the 7 dual spade connectors
  • cut of one side of 3 connectors
  • drill out the small hole on the flattened spade of the other 3 connectors to 4mm
  • place 3 M4 nuts in the 3 hex holes on the bottom of the top part
  • place the 4 drilled out connectors true the slots and with the hole over the nuts
  • put in the 3 M4 bolts. tighten them and make sure the hex head is in de correct orientation
  • flip the part over and put on the 3 cut down connectors, 3 M4 rings and 3 M4 nuts
  • when tightening the nuts make sure the bold head doesn't rotate
  • put on the bottom plate (use glue in necessary)

Put in 1 or 2 battery's and your good to go

Tags