WLED case for ESP32 and Voltage regulation board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple box case to encase all parts in one
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 209
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Build a simple WLED setup and wanted a way to enclose the ESP32 board with enough space underneath for the pins and since I went for a 24V system there needed to be a space for a common DC-DC buck converter.
For me this whole setup worked perfectly without the level shifter and only a resistor, so there is no space included for the level shifter.
Component spaces:
- ESP32
- DC DC buck converter
- 3-way 4mm² WAGO for +24V
- 5-way 4mm² WAGO for ground
- 100W Brimeti LED driver power supply
2 x M3 heat set insert nuts and 2 x countersunk head screws are required for the lid. Components are just stuck on some pins because I didn't want to bother with inserts for those. Hot glue does work fine.
I've printed mine in pla for now, if it gets to warm, I might switch it out. But mostly it doesn't.