WLED case for ESP32 and Voltage regulation board
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple box case to encase all parts in one
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 17
- Makes
- 0
- Views
- 209
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Build a simple WLED setup and wanted a way to enclose the ESP32 board with enough space underneath for the pins and since I went for a 24V system there needed to be a space for a common DC-DC buck converter.
For me this whole setup worked perfectly without the level shifter and only a resistor, so there is no space included for the level shifter.
Component spaces:
- ESP32
- DC DC buck converter
- 3-way 4mm² WAGO for +24V
- 5-way 4mm² WAGO for ground
- 100W Brimeti LED driver power supply
2 x M3 heat set insert nuts and 2 x countersunk head screws are required for the lid. Components are just stuck on some pins because I didn't want to bother with inserts for those. Hot glue does work fine.
I've printed mine in pla for now, if it gets to warm, I might switch it out. But mostly it doesn't.