1 / 3
Tilt clamp and height gear for Delta 10in table saw Model 34-335 — zdjęcie 1
1 / 3

Tilt clamp and height gear for Delta 10in table saw Model 34-335

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The tilt clamp in my old table saw broke and the parts are no longer available. So why not print them.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
87
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I printed the tilt clamp out of petg, using the following settings: 

0.2mm Structural, 4 perimeters, and 20% gyroid infill.

So far it is holding up fine. 

I not sure if the height gear will be a perfect fit because I didn't print it.

The original one was still working and I don't think petg will be strong enough for the gear, as it is made out of nylon and does show significant wear.

 

 

Tagi