1 / 3
Tilt clamp and height gear for Delta 10in table saw Model 34-335
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The tilt clamp in my old table saw broke and the parts are no longer available. So why not print them.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 87
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed the tilt clamp out of petg, using the following settings:
0.2mm Structural, 4 perimeters, and 20% gyroid infill.
So far it is holding up fine.
I not sure if the height gear will be a perfect fit because I didn't print it.
The original one was still working and I don't think petg will be strong enough for the gear, as it is made out of nylon and does show significant wear.
