RC Gearbox 9:1 Ratio for Solid-Axle Monster-Trucks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RC Gearbox 9:1 Ratio for Solid-Axle Monster-Trucks
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a 9:1 ratio gearbox designed for Drommon's Wraith Clodbuster build.
It works perfectly with a Hobbywing 3700KV 3660 motor and a 3S LiPo battery. This setup uses a Traxxas Bandit TRX 9480 differential with 500K oil.
I tested a Traxxas Slash/Stampede 2380 differential and without a center differential, but with a 3S LiPo battery, the monster truck is difficult to control.
I've uploaded the .STEP file, so you can easily make the necessary changes.
Gearbox Dimensions:
Length: 87.5 mm
Width: 42.5 mm
Height: 74 mm
Required components:
- 3660 motor with a 5mm shaft
- Traxxas TRX9480 differential
- 4x 12x6x4mm bearings
- 12x M3x10mm screws
- 5x M2,5*10mm screws
- 1x 6 x 60 mm stainless steel bolts.
Print Settings
- Printer brand:
Bambu Lab
- Printer:
Bambu P1S
- Supports:
Yes
- Resolution:
0,2
- Infill:
100
- Filament brand:
Bambu PA6CF
- Notes:
The gears were printed using Bambu PA6CF.
The housing of the first print was made from Bambu ABS-GF, but after many high jumps over two months, it broke at the motor mount. Since switching to PA6CF, there has been no breakage so far.
Drommons Wraith Clodbuster build