Dremel 3000 + Flex Shaft Holder Bracket with ventilation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Accommodates flex shaft, screw-mounted bracket for horizontal or vertical mounting - ventilation for all ports included
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a holder that would clamp onto the Dremel, and allow for screw mounting either vertical or horizontal whilst the flex shaft is installed. I also noticed that some of the holders don't include ventilation for the rear of the dremel, so mine does.
You will need to turn on supports for this. 3 perimeters minimum. I printed in PLA but PETG is probably the better choice as the clamp must flex a little when tightened. You will need M4 nut and machine screw, 12-14mm plus a washer.
I used https://www.thingiverse.com/thing:4944801 as a negative to get the fit perfect on the Dremel.
If you like my designs, consider popping a tip on https://ko-fi.com/valentineinstruments - it helps out a lot!