IKEA STÄNKREGN LED Ring Light Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall/surface mountable bracket for the IKEA STÄNKREGN.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This bracket and washer replace the original mount of the IKEA STÄNKREGN allowing you to mount it to a wall or surface.
It has a 90 degree swivel allowing it to point towards you, and also up or down depending on how you mount it. Mine is mounted under a shelf.
Including the two prints included, you'll need to disassemble the existing bracket by removing the foam layer and taking out the grub screw which allows you to remove the original ball joint, plastic washer (replaced by printed version), metal washer and spring, all of which are used in the print and assembled in the same way.
When assembling, place in the existing ball joint first. Making sure to test the orientation of how it attaches to the light itself as it only connects one way. Then put down the printed washer, allowing the gap in the washer to sit where the cut out is, this allows for a nice 90 degree swivel which the original washer didn't. Then put the metal washer, spring and finally install the grub screw to a point where you are happy with the tension on the swivel.
I've even included some little clips to keep the cable nice and tidy.
Enjoy!