1 / 5
T6 California Abdeckung für Lüftung im Hochbett — zdjęcie 1
1 / 5

T6 California Abdeckung für Lüftung im Hochbett

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

ENGLISHAs I was sometimes annoyed by strong crosswinds in the T6 California at night because it blew right into the…

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
135
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

ENGLISH

As I was sometimes annoyed by strong crosswinds in the T6 California at night because it blew right into the car through the upper ventilation openings - sometimes with rain - I developed this catch. It can be printed without support, only four magnets have to be pressed in in the end. In my case, the magnets hold without glue.

You need four magnets with the dimensions 4mm x 20mm.

I recommend PETG or stronger material, PLA becomes too soft in the sun or outside.

DEUTSCH

Da mich beim T6 California manchmal starker Seitenwind in der Nacht genervt hat, weil er durch die oberen Lüftungsöffnungen in das Auto geblasen hat - teilweise auch mit Regen - habe ich diesen Verschluss entwickelt. Es lässt sich ohne Support drucken, am Ende müssen nur vier Magnete eingepresst werden. Bei mir halten die Magnete ohne Kleber.

Ihr benötigt vier Magnete mit den Abmessungen 4mm x 20mm.

Ich empfehle PETG oder stärkeres Material, PLA wird in der Sonne bzw. draußen zu weich.

Category: Automotive

Tagi