1 / 4
Slimline enclosure for Greaseweazle 4.1 and 3.5-inch floppy disk drive. — zdjęcie 1
1 / 4

Slimline enclosure for Greaseweazle 4.1 and 3.5-inch floppy disk drive.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Slimline enclosure for a Greaseweazle version 4.1 and 3.5-inch floppy disk drive.

Ocena
0 / 5
Polubienia
14
Pobrania
129
Wydruki
2
Wyświetlenia
662
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

Slimline 3.5" floppy disk drive and Greaseweazle ver 4.1 enclosure. This is a remix of a housing for a Greaseweazle ver 4 https://cults3d.com/en/3d-model/gadget/greaseweazle-v4-case

The bottom will require supports in the screw holes but these are easily popped out by pushing a small screwdriver through the holes from above.

The top should be printed upside down (which is the way I have saved the stl file) so it does not need any supports. I printed on a textured build plate and added wide brim ears to give better bed adhesion. Printing on a smooth plate will give a nicer finish but may need adhesive on the bed to avoid the corners pulling up.

I used a temperature controlled soldering iron at 200ºC to melt brass screw mounts into the top case (I only used screws in four of the eight screw holes). The photo also shows small rubber pads on the GW support pillars but these are not necessary.

For those browsing and curious what the awesomely named Greaseweazle is, you can find out here https://github.com/keirf/greaseweazle/wiki