1 / 4
Slimline enclosure for Greaseweazle 4.1 and 3.5-inch floppy disk drive. — image 1
1 / 4

Slimline enclosure for Greaseweazle 4.1 and 3.5-inch floppy disk drive.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Slimline enclosure for a Greaseweazle version 4.1 and 3.5-inch floppy disk drive.

Rating
0 / 5
Likes
14
Downloads
129
Makes
2
Views
662
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

Slimline 3.5" floppy disk drive and Greaseweazle ver 4.1 enclosure. This is a remix of a housing for a Greaseweazle ver 4 https://cults3d.com/en/3d-model/gadget/greaseweazle-v4-case

The bottom will require supports in the screw holes but these are easily popped out by pushing a small screwdriver through the holes from above.

The top should be printed upside down (which is the way I have saved the stl file) so it does not need any supports. I printed on a textured build plate and added wide brim ears to give better bed adhesion. Printing on a smooth plate will give a nicer finish but may need adhesive on the bed to avoid the corners pulling up.

I used a temperature controlled soldering iron at 200ºC to melt brass screw mounts into the top case (I only used screws in four of the eight screw holes). The photo also shows small rubber pads on the GW support pillars but these are not necessary.

For those browsing and curious what the awesomely named Greaseweazle is, you can find out here https://github.com/keirf/greaseweazle/wiki