Loxodon, Elephantfolk Cleric 25mm (DND / TTRPG)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An Loxodon Cleric model for DND and other TTRPGs
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Characters & Monsters
- Licencja
- Creative Commons — Attribution — Noncommercial
Here is a simple cleric Loxodon / Elephantfolk model although it could just as easily work as a wizard or sorceror or even a warlock or druid model - whatever you want :)! The trickiest part was sizing and positioning the staff so that it prints well and isn't a pain to clean supports off of without worrying about it snapping.
For this I did the usual thickening up and post processing to make sure it would print nicely.
I print using a 0.2mm nozzle at 0.08mm and 100% infill - usually with the models on their back (-90 degrees on the x axis) - in general, for best results, I would recommend using the version without a baseplate and then glueing the model to the baseplate but I print with the baseplate to show that it can be done.
Category: Other