1 / 2
Feet for Vernier Physics Tracks
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was always annoyed by the Vernier Track feet, so I redesigned them so they do not stick out.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial
I love my Vernier Tracks for my Physics classes, but I found most of their equipment didn't meet my needs. I hang my tracks on the wall using bookshelf supports. But when the original feet were left on the tracks, it made it hard to stack them side by side. I redesigned the feet so they no longer stick out past the width of the track. This also helps sliding photogates and other equipment onto the track.
You will need:
- 2 ¼" square nuts to hold the feet into the model
If you don't have the Vernier feet:
- 1 ¼" by ½" bolt to hold the feet to the track
- 2 ¼" by 3" or more bolts to serve as feet. (I would cover them in rubber)
- 1 ¼" square nut to hold the feet to the track.
Enjoy!