1 / 2
Lockplates with a fingerhole for the 3way distribution with blast gate — zdjęcie 1
1 / 2

Lockplates with a fingerhole for the 3way distribution with blast gate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The small edge on the original can be finicky; I prefer fingerholes to make pulling easier.

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
90
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The small edge on the original can be finicky; I prefer fingerholes to make pulling easier.

Assembly is the same as the original lockplates.
Sand or deburr the edges for smoother sliding.
I also used WD40 Specialist PTFE dry spray lube. 
 

If it is too tight; you can scale only Z to be 0.2mm smaller in total height, this creates about 0.1mm extra clearance.
 

For some reason, the 3mf file is flipped; print it with the flat side down.


Also check my other remix; a 4040 extrusion mount for this blastgate:
https://www.printables.com/model/1235631-4040-extrusion-mount-for-3way-distribution-with-bl

Tagi