Lockplates with a fingerhole for the 3way distribution with blast gate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The small edge on the original can be finicky; I prefer fingerholes to make pulling easier.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 90
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The small edge on the original can be finicky; I prefer fingerholes to make pulling easier.
Assembly is the same as the original lockplates.
Sand or deburr the edges for smoother sliding.
I also used WD40 Specialist PTFE dry spray lube.
If it is too tight; you can scale only Z to be 0.2mm smaller in total height, this creates about 0.1mm extra clearance.
For some reason, the 3mf file is flipped; print it with the flat side down.
Also check my other remix; a 4040 extrusion mount for this blastgate:
https://www.printables.com/model/1235631-4040-extrusion-mount-for-3way-distribution-with-bl