Easy Z-Offset Calibration
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple model for Z Offset calibration
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 255
- Wydruki
- 1
- Wyświetlenia
- 901
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
The model consists of 10 sections separated by small indentations on one side, allowing enough time to manually adjust the Z offset between sections. This also makes it easier to identify the different sections later.
Use 1 Wall.
Set the infill direction to 0 degrees so that the lines will be printed horizontally.
Lighter filament colors make it easier to observe the results.
In the attached test case, the Z offset ranges from 0mm to 0.225mm, with increments of 0.025mm. At lower Z offsets, the nozzle is too close to the bed, resulting in rough surfaces and ridges. At higher Z offsets, the nozzle is too far from the bed, causing the lines to be separated.