Easy Z-Offset Calibration
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple model for Z Offset calibration
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 255
- Makes
- 1
- Views
- 901
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial
The model consists of 10 sections separated by small indentations on one side, allowing enough time to manually adjust the Z offset between sections. This also makes it easier to identify the different sections later.
Use 1 Wall.
Set the infill direction to 0 degrees so that the lines will be printed horizontally.
Lighter filament colors make it easier to observe the results.
In the attached test case, the Z offset ranges from 0mm to 0.225mm, with increments of 0.025mm. At lower Z offsets, the nozzle is too close to the bed, resulting in rough surfaces and ridges. At higher Z offsets, the nozzle is too far from the bed, causing the lines to be separated.