Barrina Grow Light Light Stand - 3 segments
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remixed version of the Barrina Grow Light Stand by @LeeWeaver_1455094 with 3 segments, fine adjustable height.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 118
- Wydruki
- 0
- Wyświetlenia
- 656
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original design was great but I needed a taller stand to be able to reach the top of bigger plants. I also didn't want to have the lights hanging from the ceiling. After some trial and error, I end up with a screw design that can be printed with no supports.
Lastly, the original design didn't fit the hight of my printer, so I had to account for that as well.
I used the same measurements as the original version by @LeeWeaver_1455094 with a few changes:
- It is now detached from the post and can be printed without supports or brims
- has a screw design to attach anywhere as long as it has the same screw design
I'll include 3MF and Fusion 360 as well.
Print instructions are on the 3MF, but overall I would say:
- Use PETG. The lamp doesn't seem to get too hot, so possibly PLA as well
- Use brims to hold the pipe up. It is a big print and it failed once with me. I added 10mm brims and honestly it might be too much
- No need for brims on the base and top cap
- 2 wall loops should provide enough strength. I personally use 3. The top pipe was very fragile around the first due to layer line weakness, but the center hole fixed that completely