Long handle / extension for Boots Deep Tissue Percussive Massage Gun
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reach those hard to reach spots you couldn't before!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Extended handle for Boots Deep Tissue Percussive Massage Gun (Boots is a British healthcare store, for those who don't know).
Print Settings
- Printer I used: White (handle) is on CR-10S, Black (bracket) was printed on an Ender 3,
- Filament: PLA,
- Layer Height: 0.2mm (0.3mm first layer),
- Nozzle Temperature: 210°C,
- Bed Temperature: 60°C,
- Supports: No,
The handle is a bit of a pain in the bum to print because it's so long. Needs a good bit of squish, and placed diagonally on a 300mm square bed.
Requirements
- 3x M3 heat set inserts (max length 5mm),
- 3x M3 washers (ones I had were 7mm OD),
- 2x M3 by 10mm bolts (in image are 12mm as it's what I had),
- 1x M3 by 30mm bolt (in image is 40mm as it's what I had).
All heat inserts go into the part of bracket which connects to handle (in the larger holes). It should be strait forward to build for most people. I may add assembly images later.
NB: I can only confirm that this is compatible with the Boots massager listed above. It attaches to pretty specific geometry on the body. I have had a look around a few places but not found a similar massager on any of the usual websites (ebay, AliExpress, Amazon & Temu).