Long handle / extension for Boots Deep Tissue Percussive Massage Gun
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Reach those hard to reach spots you couldn't before!
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 190
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Extended handle for Boots Deep Tissue Percussive Massage Gun (Boots is a British healthcare store, for those who don't know).
Print Settings
- Printer I used: White (handle) is on CR-10S, Black (bracket) was printed on an Ender 3,
- Filament: PLA,
- Layer Height: 0.2mm (0.3mm first layer),
- Nozzle Temperature: 210°C,
- Bed Temperature: 60°C,
- Supports: No,
The handle is a bit of a pain in the bum to print because it's so long. Needs a good bit of squish, and placed diagonally on a 300mm square bed.
Requirements
- 3x M3 heat set inserts (max length 5mm),
- 3x M3 washers (ones I had were 7mm OD),
- 2x M3 by 10mm bolts (in image are 12mm as it's what I had),
- 1x M3 by 30mm bolt (in image is 40mm as it's what I had).
All heat inserts go into the part of bracket which connects to handle (in the larger holes). It should be strait forward to build for most people. I may add assembly images later.
NB: I can only confirm that this is compatible with the Boots massager listed above. It attaches to pretty specific geometry on the body. I have had a look around a few places but not found a similar massager on any of the usual websites (ebay, AliExpress, Amazon & Temu).