1 / 4
Ford Model T FACT (Ford Arduino Coil Tester)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for the FACT (the display error is only in the photo).
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 233
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an enclosure for the FACT (Ford Arduino Coil Tester).
See more here: https://www.mtfca.com/phpBB3/viewtopic.php?t=9072
You will need:
4x M2 screws and nuts
4x M3 screws and nuts
9x M4 screws
3x M4 nuts
and all the electronic components…
Make sure to isolate the high-voltage screw and wire! Otherwise, the spark could jump to the Arduino/PCB (Ask me how I know…).
Also make sure to perform the testing process in portrait orientation! (As it is installed in the T).
Note: I only created the enclosure; I did not design the PCB!