1 / 4
Ford Model T FACT (Ford Arduino Coil Tester)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for the FACT (the display error is only in the photo).
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 233
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an enclosure for the FACT (Ford Arduino Coil Tester).
See more here: https://www.mtfca.com/phpBB3/viewtopic.php?t=9072
You will need:
4x M2 screws and nuts
4x M3 screws and nuts
9x M4 screws
3x M4 nuts
and all the electronic components…
Make sure to isolate the high-voltage screw and wire! Otherwise, the spark could jump to the Arduino/PCB (Ask me how I know…).
Also make sure to perform the testing process in portrait orientation! (As it is installed in the T).
Note: I only created the enclosure; I did not design the PCB!