Tronxy P802E Bed Spring Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Having the bed shift on the wobbly springs mid print is very annoying so here is my answer.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Having the bed shift on the wobbly springs mid print is very annoying so here is my answer. A cup part on one end and a post on the inside on the other. This tightly constrains the spring while still allowing plenty of adjustment range. These were made to fit my springs snugly. You might need to scale slightly.
Also throwing in my thumb nut extension part. They press on tight over the nuts that came with my printer.
Print instructions
Category: 3D Printer Parts Print Settings
Printer: Tronxy p802e
Rafts: No
Supports: No
Notes:
Use the highest temperature plastic that you have handy. PLA is ok until you heat the bed above 60C.
Post-Printing
if the springs are too tight then adjust the scale and try again.