Dry Box Spool Holder with Bearings (easier print)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix to make the non-hydrometer model to lay flat on the print bed with printable planetary spool bearings.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 239
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a rework to make one model easier to print and another model to function as a bearing for a standard 1kg filament spool.
Similarly to the previous model you will need:
- (6) M4 x 12mm screws (to attached the base to the dry box lid)
- (6) M4 Nuts
You will need to print the following for a set:
- (1) Base
- (1) Hangar Rung L
- (1) Hangar Rung R
- (1) Pin
- (2) Bearings.
I used (General):
- MK4S
- PLA/PETG (both seem to work fine)
- 0.4 Nozzle.
Base and Rungs (to get the honeycomb pattern):
- (0) Zero top and bottom layer height.
- Honeycomb infill pattern.
Bearings/Pin:
- Standard preset heights top/bottom layer heights.
- Switched to Gyroid infill. (PETG only)
The idea for this was to allow the hanger to be printed flat in 3 separate pieces, which makes it easier to remove the top and bottom layers, exposing the fill pattern (if you want to).
The bearing part was just resized and reshaped to fit a normal 1KG spool. I also designed a square shaped shaft pin with built in clips on each end removing the need for screws.
I originally intended on making a mechanism to rewind the spool without removing it, but ran out of time for it right now. Maybe in the future.