1 / 1
Adafruit car horn - part 2 - box for 10 position switch
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
box for 10 position switch
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The Car Horn project:
Part 2: the 10 position switch
I added the tubes on the side of the box for wire management. I also slathered it in hot glue after soldering connections. I'm not sure whether the glue is good or bad. For mounting I'll need to drill 3 holes and might need a stand off. The mounting screws are M3.