1 / 1
Adafruit car horn - part 2 - box for 10 position switch
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
box for 10 position switch
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 6
- Makes
- 0
- Views
- 37
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
The Car Horn project:
Part 2: the 10 position switch
I added the tubes on the side of the box for wire management. I also slathered it in hot glue after soldering connections. I'm not sure whether the glue is good or bad. For mounting I'll need to drill 3 holes and might need a stand off. The mounting screws are M3.