1 / 3
Livestock Water Tank Heater Nut
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement nut for attaching a livestock water heater.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 351
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This is a replacement nut for attaching a livestock water heater. I made it much thicker than the original both for strength, but also just so it was easier to turn on. It was a tight fit at 100% scale, but still usable. I printed again at 101% (x&y only) and it was just right. I printed with both pla and abs. I will use the abs one and keep the other around just in case.
Print instructions
Category: Outdoor & Garden Print Settings
Rafts: No
Supports: No
Resolution: .2 mm
Infill: 20% max
Notes:
Obviously, you need to rotate it flat to print.