1 / 8
Artillery Hornet Dragonburner V8 adapter for MGN9 rail V2.1 — zdjęcie 1
1 / 8

Artillery Hornet Dragonburner V8 adapter for MGN9 rail V2.1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dragonburner upgrade for Artillery Hornet

Ocena
0 / 5
Polubienia
7
Pobrania
27
Wydruki
0
Wyświetlenia
512
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

New version of adapter to use Dragonburner v8 tool head with it's many hotend and extruder options to Artillery Hornet printer via MGN9 rail with C/H blocks. Made in separate parts for better printing, but still requires supports. To be less dependent on printer precision, uses metal hardware for mounting and assembly.

Edit 02.05.2025: Made belt mount shorter by 2mm for it not to hit POM wheel screw.

Currently tested with:
Hotends: E3D V6 clone, TZ 2.0 from Ali
Extruders: Sherpa Mini with Nema 17(https://www.thingiverse.com/thing:5980774), Sherpa Mini with Voron Nema14

Has 3d/BLTouch mount (X - 43, Y - 13, not tested yet, might change). Version without bltouch might be out a bit later due to my personal time constraints. Other versions will also appear, but might require feedback from users.

(I am aware of a few problems like clearance for bltouch cable and cable ties holes for securing cables)

Be aware that this upgrade will require you to make a separate set of cables for everything, so be careful. Also a pid tune for hotend and settings for heater and thermistor will have to be changed in the firmware depending on your combination, extruder will require an E-steps recalibration.

If you have 5015 cooling on your hornet
(Like this https://www.thingiverse.com/thing:5382834 or this
https://cults3d.com/en/3d-model/gadget/artillery-hornet-5015-dual-fan-duct-with-three-air-outlets-in-the-layer-ventilation-3dmakeres ),
you can try to print from GCode file, but I'm not sure about cooling because I use Klipper and it overrides whatever command for fanspeed from Cura, so you might want to babysit it.

PARTS WILL REQUIRE POST PROCESSING LIKE SANDING AND TRIMMING

Bill Of Materials
Filament: 10m PETG
Hardware:
DIN912 / ISO4762 M3x8 x8 (4 for mounting to MGN9 block, 2 for Top Plate and 2 for secure toolhead ducts)
DIN912 / ISO4762 M3x25 x2 (2 for Belt mount)
DIN912 / ISO4762 M3x11 x2 (for Bltouch)
M3 7x0.5mm washers x2 (optional for bottom block mounting screws)
M3 nuts x4 (2 for belt mount, 2 for Bltouch)
M3x5mm heat inserts x2 (2 for top plate, 2 for long dragonburner m3 screws)
1m GT2 belt (Most likely you will need to replace stock with longer one)

  • whatever hardware for Dragonburner toolhead and MGN9 rail.

If you have any feedback be free to comment here or on Printables. Idea for mount from 3D Printer Guy.

Tagi