1 / 7
RobotDigg Spool holder with 608ZZ skate bearing inserts — zdjęcie 1
1 / 7

RobotDigg Spool holder with 608ZZ skate bearing inserts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I could not find anything on Thingiverse that fit my RobotDigg PLA spools so I made this 4 mm thick spool holder,…

Ocena
5 / 5
Polubienia
3
Pobrania
33
Wydruki
1
Wyświetlenia
479
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

I could not find anything on Thingiverse that fit my RobotDigg PLA spools so I made this 4 mm thick spool holder, quick print. With a small mod you could adapt it to fit any 200 mm diameter spools. Fits 21.93 mm diameter skate bearings, nice friction fit with a taper at the back to keep the bearing from being pushed into the spool. The Robot Digg spools Have a 38.14 mm diameter hole. 104 mm from center to base so fits the 200 mm diameter Robot Digg spool. The cross members are a tight fit so tapping them on with a small hammer and a drop of crazy glue makes a nice strong connection. Leave the little bag of desiccant in the spool so it doesn't back spool, the bearings are very smooth. I'm using a 6.26 mm bolt in the pic but it is sized for 7.75 mm threaded rod.

Instructions

Print it, tap the cross supports on, put a drop of crazy glue at the connection. Press in the bearings, put them in the reel and thread a bolt or section of threaded rod with a couple washers through the whole thing. Leave the little bag of desiccant inside the spool so it doesn't back spool.

Category: 3D Printer Accessories

Tagi