1 / 4
Lowrider V3  gantry Y axis endstop removal and table auto square for dule pole setups — zdjęcie 1
1 / 4

Lowrider V3 gantry Y axis endstop removal and table auto square for dule pole setups

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Places the Y axis endstop on table with/without hard stop and helps square the Lowrider V3 CNC 2 pole Y axis setups

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
51
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

If your table is Square and you're running two pols for the Y axis, mount the pole flush to the print and the print flush to the table. Mount one pole bracket, push the cnc gantry up/down the entire length aligning pols parallel.  Return to original position and mount the other side pole bracket keeping it flush to the table. Move the gantry up/down the entire lengths again. Return to the pole bracket below the one just mounted and mount both sides.  Roll the gantry up/down again and repeat the process.  All the while make sure the gantry doesn't bind or lift off the pols. When all pole brackets have been mounted apply a final tighten and assure the gantry still travels along the pols smoothly one more time.

Tagi