Lowrider V3 gantry Y axis endstop removal and table auto square for dule pole setups
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Places the Y axis endstop on table with/without hard stop and helps square the Lowrider V3 CNC 2 pole Y axis setups
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 51
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
If your table is Square and you're running two pols for the Y axis, mount the pole flush to the print and the print flush to the table. Mount one pole bracket, push the cnc gantry up/down the entire length aligning pols parallel. Return to original position and mount the other side pole bracket keeping it flush to the table. Move the gantry up/down the entire lengths again. Return to the pole bracket below the one just mounted and mount both sides. Roll the gantry up/down again and repeat the process. All the while make sure the gantry doesn't bind or lift off the pols. When all pole brackets have been mounted apply a final tighten and assure the gantry still travels along the pols smoothly one more time.