Desktop fume extractor with exhaust
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Please. Mr. Suckface was my father.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Googly eyes not included.
This is a redesign of my previous fume extractor, made to be a bit sleeker on the outside and to have the exhaust come out of the side instead of the front for easier use. I also added a foot for stability, and that lip around the edge that lets you tip it over for more focused flow.
I used tree supports for the back half while printing it. Don't forget to turn on Z hop for those. The front half can simply be printed on the flat side.
The inside is sized around a 120mm fan, and can accommodate anything up to a 40mm in thickness. Unlike my previous design, the fan is now fully enclosed. To allow for mounting access, threaded inserts are used to hold the two parts together, as otherwise you would not be able to physically screw the fan in. They're put in the holes of the back half.
The filters used are the 13x13x1cm ones, as used by the little Hakko and most other small fume extractors.
The exhaust hose used is a 4in dryer hose, which I have leading outdoors.