Topping E30 and L30 stack shelf holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little shelf in which you can put your topping stack. It prevents the top one from sliding around on the bottom one…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 732
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
A little shelf in which you can put your topping stack. It prevents the top one from sliding around on the bottom one and getting misaligned.
The top unit is secured pretty good since its feet fit nicely into the holes, however, the bottom unit can still slide forward and backward.
Print Settings
Printer Brand:
Anycubic
Rafts:
Doesn't Matter
Yes
Infill:
100%
Filament:
Sunlu PLA Black
Notes:
I printed this on an Anycubic i3 Mega with some cheap PLA, but you can use anything else as this model doesn't have a lot of detail.
I had to enable supports otherwise the holes would come out looking pretty bad, however, you may not need them.
Category: Audio