1 / 2
Elbow Hose Tail for Oase FiltoClear pond filters
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Elbow hose tail for Oase FiltoClear pond filters. Fits models FiltoClear 3000-15000.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (10)Powiązane
Due to space restrictions, I designed and printed an elbow hose tail fitting Oase FiltoClear 3000-15000 products. I tested it with FiltoClear 3000. According to some information I found, it should also fit the other FiltoClear products.
The model is printed using two parts:
- FilterPart attaches to the filter. It's required to add the hosetail nut to it before screwing in the HosePart
- HosePart is designed for a 1 inch (25 mm) i.d. hose
Print instructions:
I followed instructions given in this article to make the print watertight.
Post print processing:
- You may use a sharp knife to screw the HosePart into the FilterPart.
- Use some silicon to make sure the connection is watertight.
Print details:
| Printer | Prusa MK4S |
| Material | PETG Prusament Orange |
| Nozzle | 0.4 mm |
| Layer Height | 0.15 mm |
| Supports | Support for the thread is recommended |
| Perimeters | 5 |
| Solid layers | Top: 8; Bottom: 7 |
| Infill | 50% |
| Nozzle temperature | 1st layer: 250°C, then 260°C (10° above presets) |
| Extrusion multiplier | 1.1 (10% above preset) |