1 / 2
Elbow Hose Tail for Oase FiltoClear pond filters
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Elbow hose tail for Oase FiltoClear pond filters. Fits models FiltoClear 3000-15000.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 48
- Makes
- 0
- Views
- 224
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
Due to space restrictions, I designed and printed an elbow hose tail fitting Oase FiltoClear 3000-15000 products. I tested it with FiltoClear 3000. According to some information I found, it should also fit the other FiltoClear products.
The model is printed using two parts:
- FilterPart attaches to the filter. It's required to add the hosetail nut to it before screwing in the HosePart
- HosePart is designed for a 1 inch (25 mm) i.d. hose
Print instructions:
I followed instructions given in this article to make the print watertight.
Post print processing:
- You may use a sharp knife to screw the HosePart into the FilterPart.
- Use some silicon to make sure the connection is watertight.
Print details:
| Printer | Prusa MK4S |
| Material | PETG Prusament Orange |
| Nozzle | 0.4 mm |
| Layer Height | 0.15 mm |
| Supports | Support for the thread is recommended |
| Perimeters | 5 |
| Solid layers | Top: 8; Bottom: 7 |
| Infill | 50% |
| Nozzle temperature | 1st layer: 250°C, then 260°C (10° above presets) |
| Extrusion multiplier | 1.1 (10% above preset) |