Abstract Octagon Fidget Spinner with one 608 Bearing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This my attempt at creating a spinner with a completely different look. It's great for small hands (65mm x 65mm). Enjoy!
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
This spinner was a personal challenge to come up with something that looked different from my other spinners. I also wanted to design something that printed quickly. On my Anycubic Kobra Pro 2, the spinner and caps only took 31 minutes to print at a .16mm layer height and with a 100% infill.
I have some friends who are counselors and often have younger clients who tend to open up more when they have something to “fidget” with. So, I print out a lot of spinners for them and wanted to have some original designs that only use a single 608 bearing and fit those with smaller hands.
I got great spin-time from a cheap 608 bearing off of Amazon. I'm sure there are a lot better bearings that could increase spin time, but the cheap ones worked just fine for me. The bearing caps are a remix that I came up with.
Note: The bearing is a tight fit. I use two pieces of wood to sandwich the spinner and bearing then press down until the bearing seats fully. It's not too difficult but does take a little effort.
Links:
- Bearing Caps: https://www.printables.com/model/1221928-fidget-spinner-bearing-cap-for-608-bearings
- Here is an Amazon link to the bearings I used: https://a.co/d/iMTwe83
Printing:
- Supports: None
- Infill: I recommend 100% to provide weight.
- Layer Height: I use .16 but .2 should work just fine.
- Material: PLA