Retainer Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My retainers were too large for any of the models on printable so I made my own
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The model is fully 3D printed (no extra parts required) and the lid and box should just snap together, although this took quite a bit of work from me and a little bit of lost material, but this ensured the hinge was as strong as possible.
The bottom of the box has a sloped base and small holes to allow water to flow out, so for this I would recommend slicing with a variable layer height (gcode attached for MK4), and also keeping the box on a not-so-flat surface or a small cloth may help as the base is so flat it forms a seal with other flat surfaces - this may not be a problem with textured build plates.
It also has a closing latch mechanism which has not given me any problems.