Retainer Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My retainers were too large for any of the models on printable so I made my own
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 59
- Makes
- 0
- Views
- 192
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The model is fully 3D printed (no extra parts required) and the lid and box should just snap together, although this took quite a bit of work from me and a little bit of lost material, but this ensured the hinge was as strong as possible.
The bottom of the box has a sloped base and small holes to allow water to flow out, so for this I would recommend slicing with a variable layer height (gcode attached for MK4), and also keeping the box on a not-so-flat surface or a small cloth may help as the base is so flat it forms a seal with other flat surfaces - this may not be a problem with textured build plates.
It also has a closing latch mechanism which has not given me any problems.