Fjellpulken sled wheels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapters to fit Biltema wheels to fjellpulken to transport the sled to the tracks.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Disclaimer
I will start with a disclaimer that this model is by no means rigorously tested nor verified with Fjellpulken that it is ok and safe to use. But, it has made my life so much easier this winter so I figured I should share it. It has worked flawlessly for me, but use at your own risk!
Necessary hardware:
- 17 M6 nuts
- 12 M6x20mm hex bolts
- 12 8.4x16.1.6mm washers (or similar)
- 5 M6x40mm hex bolts
- 1 front wheel from Biltema. Part number 41-1066
- (https://www.biltema.no/bygg/beslag/transporthjul/hjul-med-sving-og-bremse-25-x-80-mm-2000050300)
- 2 back wheels from Biltema. Part number 41-1063
- (https://www.biltema.no/bygg/beslag/transporthjul/fast-hjul-25-x-80-mm-2000050297)
Printing instructions
I recommend printing the 17 nut inserts first, since they are needed for the adapters.
The front wheel adapter should be printed on its side and needs to be paused at 3 locations to insert the nuts.
The back wheel adapters only need to be paused at 1 location to insert all the nuts.
I have printed in both pla and petg and both seem to work fine. I do recommend petg for the front wheel adapter since when tightening the screw the adapter bends around the pole better. I have used 15% gyroid infill and 4 walls for strength (with a 0.4mm nozzle), but it will probably work with other settings as well.
The adapters should be fastened with M6x20 bolts and you probably need the washer for the bolt not to pass through the wheel base.
The M6x40 bolts are to be used for the tightening screws. The fastener handle is to make it easy to tighten the bolts by hand and for the back wheels the tightening screw cap can be mounted after you have screwed the bolt into the adapter.
If you need to make som adjustments for your printer or setup, you can find the cad model here (you need to create an onshape account first): https://cad.onshape.com/documents/82e54dc4160c028d801bd544/w/86d7f38f4851e19e6f788a7f/e/6e1b7d253d2ce7e79c9040c5