Spool holder Anycubic Kobra S1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a sturdy and practical spool holder for the Kobra S1
- Ocena
- 4,857 / 5
- Polubienia
- 108
- Pobrania
- 973
- Wydruki
- 8
- Wyświetlenia
- 4432
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a sturdy and practical spool holder. This design lets you clearly see your spool, and you can mount the spool either at the front or back!
✔ No supports needed – prints easily and cleanly
✔ Simple installation – just a few screws required
✔ Customizable mounting – place your spool where it suits you best
Printing & Assembly:
I've used: 0.20mm layer height, 15% grid infill
Requires three M3 screws (~15mm long) for mounting
An M3 screw secures the shaft (I used the original screw from the back)
I’ve put a lot of time into designing this and plan to improve it further—perhaps adding bearings in the future. While it’s not mandatory, a small contribution would be greatly appreciated!