Spool holder Anycubic Kobra S1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a sturdy and practical spool holder for the Kobra S1
- Rating
- 4.857 / 5
- Likes
- 108
- Downloads
- 973
- Makes
- 8
- Views
- 4,432
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is a sturdy and practical spool holder. This design lets you clearly see your spool, and you can mount the spool either at the front or back!
✔ No supports needed – prints easily and cleanly
✔ Simple installation – just a few screws required
✔ Customizable mounting – place your spool where it suits you best
Printing & Assembly:
I've used: 0.20mm layer height, 15% grid infill
Requires three M3 screws (~15mm long) for mounting
An M3 screw secures the shaft (I used the original screw from the back)
I’ve put a lot of time into designing this and plan to improve it further—perhaps adding bearings in the future. While it’s not mandatory, a small contribution would be greatly appreciated!