1 / 2
XIAO ESP32S3 Wio-SX1262 Meshtastic Enclosure with 18650 Battery for Desktop — zdjęcie 1
1 / 2

XIAO ESP32S3 Wio-SX1262 Meshtastic Enclosure with 18650 Battery for Desktop

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A compact Meshtastic enclosure for Desktop use or portable. Uses a 18650 battery.

Ocena
4,333 / 5
Polubienia
40
Pobrania
372
Wydruki
1
Wyświetlenia
3002
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

What You'll Need:


18650 Battery Holder - https://amzn.to/4lnV6ej
Double-sided Foam Tape - https://amzn.to/4kRXAzW
Lora Antenna and IPEX-1 to SMA - https://amzn.to/3FJuHXS

Or get this and use your favorite SMA antenna:
IPEX-1 to SMA Female - https://amzn.to/43q5CuV

The Module:
esp32 s3 lora Meshtastic Lora,SX126, 868mhz 915mhz antenna, XIAO ESP32S3 for Meshtastic & LoRa starter kit,LoR... https://www.aliexpress.us/item/3256807908323566.html?channel=twinner

https://www.seeedstudio.com/Wio-SX1262-with-XIAO-ESP32S3-p-5982.html

Put It Together:

A WARNING to begin… Any time that you plug the device into a USB port, please make sure that you have both antennas connected. Use the tiny antenna that is included with the SEEED Studio device when you open the box to press the boot button when flashing your device.

I printed my parts on a Bambu A1 using the AMS, so I split the body and did a multicolor print. I have included that file as a .3mf if you have the ability to switch filament mid-print.

Print the pieces face down. While it is printing, solder the positive and negative leads from the battery holder to the bottom of the ESP32. Once printed, screw the battery holder into place in the bottom of the enclosure. Slide the pins of the ESP32 and SX-1262 into the cradle on the bottom of the enclosure.  Secure it with double-sided foam tape. You may need more than one layer of tape.

Notes:

This chip seems to last about 12 to 16 hours on a single charge. You might be able to get better battery life by adjusting some of the settings in Meshtastic.

I didn't design a place for any peripherals for this one. SEEED Studios sells a 3D printed case that has a pass through for jumper wires. I may look into that in the future if there is any demand for it. Due to the battery life of 18650 type cells, adding extra components shortens the run time, so I designed this for a primarily sedentary lifestyle. The battery is mostly for keeping it powered while moving it around when it isn't plugged in.

Tagi