Resistor storage for a drawer organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert into a drawer organizer to keep your resistors sorted
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Description
I used to have my resistors randomly distributed in my drawer organizer, so whenever I needed a specific resistor value, the finding process could be quite long, and they often got stuck. I therefore designed this insert into my 141 x 54 x 33 mm drawers. It can be used with diodes or any devices of approximately the same size as well.
Here's where I have my organiser from: https://www.hornbach.cz/p/skrinka-zavesna-m6761/4285926/
Labels
Since the drawers are too short to fit two resistors in series, I had no Idea where to put labels in the design. Then I came up with the idea of adding them in the middle as a single sliding part which can be labeled from both sides, each for each set of five storage spaces.
Additional resistor holders
For a better removal of the resistors from the organizer, I decided to add another sliding elements that will hold your resistors while facilitating the removing process.
Assembly
To put everything together, simply insert the storage part into your drawer(s) and slide the label in. If you don't want to print the sliding resistor holders, you can just insert a small sheet of a stiffer paper or a plastic foil to easily remove your resistors later.
Printing
- No supports needed
- printed with a PLA filament with the basic setting of the Bambu studio slicer