Helldivers 2 Skull Bead
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple beads based off the Helldivers 2 skull icon, with a 5mm hole diameter.
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 140
- Wydruki
- 1
- Wyświetlenia
- 432
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
These beads are based off the Helldivers 2 skull icon used in a variety of places. I've included flat and faceted variants, and ones with a nose-hole and without.
It prints well at 0.2mm layer height, I went for 3 walls and 20% infill but you could likely get away with less. Also added a small brim because I don't trust my bed adhesion sometimes. If choosing to print the faceted versions face-down, don't forget to support the cheekbones (like I did)! Not the end of the world if you don't due to the small scale, it just comes out a little rough on the underside.
I only recommend printing the ones with nose holes if you're SLA printing or have a very fine nozzle, since my trial print failed at the nose almost completely. On that note, please excuse the awful print quality in the photos, my PLA is not in a good state…